Page 1 of 833 123451151101501 ... LastLast
Threads 1 to 20 of 16646

Forum: GM V8 Tuning - Engine, Gas (Gen 4)

(2005-2015, LS2, LS7, ...)

  1. Sticky Thread Sticky: Read Me!!! Tuning How-To's & General Information

    Started by Bill@HPTuners, 01-06-2007
    3 Pages •
    1 2 3
    3 Attachment(s)
    • Replies: 40
    • Views: 247,807
    TheMechanic
    06-06-2023 Go to last post

  1. "OL-Not Ready" with EQ Cmd 15.97. Why and from where...

    Started by S-351R, 03-06-2023
    3 Attachment(s)
    • Replies: 10
    • Views: 1,093
    C6_daily
    32 Minutes Ago Go to last post

  2. 2007 silverado 5.3 FSCM

    Started by nickweidling, 39 Minutes Ago
    • Replies: 0
    • Views: 2
    nickweidling
    39 Minutes Ago Go to last post

  3. 5.3 Swap Starts then Dies

    Started by angelm_ix, 22 Hours Ago
    4 Attachment(s)
    • Replies: 10
    • Views: 140
    blindsquirrel
    1 Hour Ago Go to last post

  4. Ls3 Log e85 boost target AFR WOT

    Started by Chad1234hol, 1 Hour Ago
    • Replies: 0
    • Views: 19
    Chad1234hol
    1 Hour Ago Go to last post

  5. Heat Soaked Restart Issues

    Started by Cringer, 1 Week Ago
    3 Pages •
    1 2 3
    20 Attachment(s)
    • Replies: 58
    • Views: 1,929
    STAGEUP
    3 Hours Ago Go to last post

  6. (Almost) New to HP Tuners

    Started by Shroomun, 1 Day Ago
    • Replies: 4
    • Views: 118
    JayRolla
    3 Hours Ago Go to last post

  7. A few questions regarding swapping OS

    Started by Agtronic, 5 Hours Ago
    • Replies: 4
    • Views: 71
    blindsquirrel
    3 Hours Ago Go to last post

  8. ECM 14072 test for missfire

    Started by obthomas, 5 Hours Ago
    • Replies: 3
    • Views: 51
    gtstorey
    4 Hours Ago Go to last post

  9. What am I missing? Open Loop Delay?

    Started by CTSVNZ, 11 Hours Ago
    3 Attachment(s)
    • Replies: 8
    • Views: 159
    Alvin
    5 Hours Ago Go to last post

  10. Cammed Ve Ss Manual L98

    Started by troyjago, 1 Day Ago
    6 Attachment(s)
    • Replies: 7
    • Views: 151
    troyjago
    5 Hours Ago Go to last post

  11. Does 6l80 function safely with MAF tune only?

    Started by NastyLS3, 6 Days Ago
    • Replies: 9
    • Views: 395
    Alvin
    6 Hours Ago Go to last post

  12. Adjusting cooling fans to operate at highway speeds if needed?

    Started by [email protected], 08-05-2022
    • Replies: 19
    • Views: 2,054
    eficalibrator
    6 Hours Ago Go to last post

  13. Operating OS's 1250216 & 1250219 compatibility

    Started by Guy With A Chevy, 1 Day Ago
    1 Attachment(s)
    • Replies: 10
    • Views: 266
    gtstorey
    6 Hours Ago Go to last post

  14. Help Tuning VVE / Start and run, but not idle

    Started by Loose_Screws, 3 Days Ago
    3 Pages •
    1 2 3
    36 Attachment(s)
    • Replies: 48
    • Views: 862
    LS ROB
    19 Hours Ago Go to last post

  15. Tuning MAF and VVE at the Same Time

    Started by Cringer, 04-04-2023
    12 Pages •
    1 2 3 ... 12
    30 Attachment(s)
    • Replies: 225
    • Views: 38,040
    DobermanRacing
    21 Hours Ago Go to last post

  16. Post Bad E38 ECM?

    Started by Richard F., 1 Day Ago
    4 Attachment(s)
    • Replies: 14
    • Views: 231
    TheMechanic
    1 Day Ago Go to last post

  17. Fuel trims sporatic randomly.

    Started by 8aHemi, 3 Days Ago
    5 Attachment(s)
    • Replies: 14
    • Views: 417
    edcmat-l1
    1 Day Ago Go to last post

  18. Camaro ls3 boost e85 wot

    Started by Chad1234hol, 5 Days Ago
    2 Attachment(s)
    • Replies: 4
    • Views: 257
    Alvin
    1 Day Ago Go to last post

  19. 2009 Escalade E38 ECM Programming Problems

    Started by jimtruett, 2 Weeks Ago
    • Replies: 3
    • Views: 248
    Alvin
    1 Day Ago Go to last post

  20. Such thing as too low idle?

    Started by dassaur, 3 Days Ago
    • Replies: 5
    • Views: 201
    Alvin
    1 Day Ago Go to last post
Page 1 of 833 123451151101501 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.