Register
Help
Remember Me?
What's New?
Activity Stream
New Posts
New Events
Mark Forums Read
Forum
Advanced Search
Home
Activity Stream
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
3 Minutes Ago
StawkSlowC6
started a thread
DQ250 tune...cable needed?
in
Audi/VW
Hey Folks, Have a 2014 MK6 GLI unfortunately has a Simos 12.2 ECM so no tuning available there, but I have the DQ250 DSG trans, and when I connect...
see more
0 replies | 0 view(s)
42 Minutes Ago
SiriusC1024
replied to a thread
Need help with first start
in
GM V8 Tuning - Engine, Gas (Gen 3)
Why is BRAF so high? You're trying to idle at 90kPa. Spark is being retarded to maintain idle due to excess airflow.
see more
49 replies | 1314 view(s)
44 Minutes Ago
Supspt454
replied to a thread
411 Swap 383 Vortec 97 GMC Sierra C1500
in
GM V8 Tuning - Engine, Gas (Gen 3)
Hi. Thanks for taking a look. The injectors are just the stock replacement MPFI conversion spider. I was going to use AUS Injection spider with...
see more
2 replies | 26 view(s)
44 Minutes Ago
radeon1337
started a thread
Can someone evaluate a remote tune for me?
in
GM V8 Tuning - Engine, Gas (Gen 4)
I was hoping someone could skim this and see if this tune is decent or safe. Someone referred to it as a "Kill Tune" and I'm leery of driving the car...
see more
0 replies | 14 view(s)
55 Minutes Ago
ronbo422
replied to a thread
VCM Scanner question after LT headers5rftg z
in
Dodge Tuning - Engine, Gas
I found that my transport delay adjustment was only saved to bank 2, where I only had 3% added to the entire table. Upon further research, I have...
see more
4 replies | 121 view(s)
59 Minutes Ago
Richard2325
started a thread
Help wiring wideband to 0411 PCM EGR
in
VCM Scanner
Hey guys, I'm pretty new to tuning. I recently purchased an AEM 30-300 wideband to do some tuning as I just did a truck norris cam swap. I am...
see more
0 replies | 10 view(s)
1 Hour Ago
LeadFootedRacer
replied to a thread
Need help with first start
in
GM V8 Tuning - Engine, Gas (Gen 3)
I'll give that a read. I know to really dial in the idle, the rest of the tune needs to be fairly close... so I will keep at it. Here is a current...
see more
49 replies | 1314 view(s)
1 Hour Ago
Seishuku
replied to a thread
ford escape mk4 2.0L ecoboost stage3 tuning help
in
Ford Tuning - Engine, Gas (Ecoboost)
Give this a try
see more
11 replies | 429 view(s)
1 Hour Ago
blindsquirrel
replied to a thread
Getting some kind of fuel cut or leaning out when under heavy throttle.
in
GM V8 Tuning - Engine, Gas (Gen 3)
Also needs injector data. I don't care if every file they supply to everybody who buys their kits is like this, it's still wrong.
see more
3 replies | 23 view(s)
1 Hour Ago
SiriusC1024
replied to a thread
411 Swap 383 Vortec 97 GMC Sierra C1500
in
GM V8 Tuning - Engine, Gas (Gen 3)
Needs some airflow tuning. O2 switch points (Fuel>Oxygen Sensors>Rich/Lean vs. Airflow) are on the rich side. Try 412 for 0-2, 496 for 12-16,...
see more
2 replies | 26 view(s)
1 Hour Ago
blindsquirrel
replied to a thread
Getting some kind of fuel cut or leaning out when under heavy throttle.
in
GM V8 Tuning - Engine, Gas (Gen 3)
see more
3 replies | 23 view(s)
1 Hour Ago
Supspt454
started a thread
411 Swap 383 Vortec 97 GMC Sierra C1500
in
GM V8 Tuning - Engine, Gas (Gen 3)
Newbie still trying to learn. Wondering if someone will look over my quick drive log and current tune and point me in the direction to start. Don't...
see more
2 replies | 26 view(s)
1 Hour Ago
SiriusC1024
replied to a thread
Getting some kind of fuel cut or leaning out when under heavy throttle.
in
GM V8 Tuning - Engine, Gas (Gen 3)
Give a time stamp.
see more
3 replies | 23 view(s)
1 Hour Ago
DodgeBoy_8HP
replied to a thread
VCM Scanner question after LT headers5rftg z
in
Dodge Tuning - Engine, Gas
Share the logs and tune. I believe you will find answers..
see more
4 replies | 121 view(s)
1 Hour Ago
blindsquirrel
replied to a thread
Need help with first start
in
GM V8 Tuning - Engine, Gas (Gen 3)
https://www.pcmofnc.com/2021/03/05/idle-setup-cable-driven-throttle-body/
see more
49 replies | 1314 view(s)
1 Hour Ago
Firebird94
started a thread
Getting some kind of fuel cut or leaning out when under heavy throttle.
in
GM V8 Tuning - Engine, Gas (Gen 3)
Hello all, I'm very new to tuning and trying to do as much of my own research as possible but was hoping that maybe someone in here could get me...
see more
3 replies | 23 view(s)
1 Hour Ago
Tom @ Overdrive
replied to a thread
Speed density going wildly lean 2012 Sierra Denali L9h
in
GM V8 Tuning - Engine, Gas (Gen 4)
When you put it in open loop, it's stops using the o2's. It's using the o2's to estimate ethanol content. With no closed loop doing the math it can...
see more
14 replies | 324 view(s)
2 Hours Ago
Imnew
replied to a thread
2011 cruze RS 1.4T stock tune
in
Lounge
here is my stock file to my 2011 cruze lt
see more
1 replies | 123 view(s)
2 Hours Ago
NORIEGABROS
replied to a thread
Cadillac CTS 3.6 2011 problem with long term fuel
in
GM V6 Tuning - Engine
Can I tune my 2015 SRX with a better fuel efficiency and remove stabilitrack? this car swallows gas stations!!
see more
3 replies | 322 view(s)
2 Hours Ago
NORIEGABROS
replied to a thread
2013 Cadillac XTS Tuning
in
GM V6 Tuning - Engine
Can I use this tune on my 2015 SRX with the 3.6 engine? I just need gas mileage to improve and the annoying stabilitrack disabled on my Cadillac....
see more
3 replies | 90 view(s)
2 Hours Ago
MAIDENCR
replied to a thread
hitting a limiter going into 4th gear
in
Dodge Tuning - Engine, Diesel
55psi seam to be a good number...depend on duration
see more
8 replies | 447 view(s)
2 Hours Ago
LaRue
replied to a thread
FRPP fuling issues
in
Ford Tuning - Engine, Gas (Non Ecoboost, US)
yes, I know. With the correct data its not fueling correctly, only way to somewhat correct fueling was to start cutting the injector size Then the...
see more
3 replies | 163 view(s)
2 Hours Ago
Lakegoat
replied to a thread
Speed density going wildly lean 2012 Sierra Denali L9h
in
GM V8 Tuning - Engine, Gas (Gen 4)
You have some high KPA readings at low rpms. Are you driving with your foot on the brake? What is the MAP reading at key on---engine off? Looks...
see more
14 replies | 324 view(s)
2 Hours Ago
Ragetune
replied to a thread
T87 ATS Allison 1000 6 speed in a dodge ram cummins file insode
in
GM V8 Tuning - Transmission
I added one with corrected for 35" and 3.42. The first one ats set it up for 4.10 and 48" lol
see more
1 replies | 29 view(s)
3 Hours Ago
LeadFootedRacer
replied to a thread
Need help with first start
in
GM V8 Tuning - Engine, Gas (Gen 3)
Found that torque management was retarding the timing substantially. I?ve disabled it and now I can start logging things. I?m still getting higher...
see more
49 replies | 1314 view(s)
3 Hours Ago
Ragetune
started a thread
T87 ATS Allison 1000 6 speed in a dodge ram cummins file insode
in
GM V8 Tuning - Transmission
Here is a read from a t87 standalone setup. Anyone play with these?
see more
1 replies | 29 view(s)
3 Hours Ago
charcoal03silvy
replied to a thread
Help with tuning for a 6.2 f250 2011 14 maps
in
Ford Tuning - Miscellaneous
Sounds like you need to learn about Ford's HDFX logic :) Plenty of good reads here on the forums of how it works or other places online. ...
see more
1 replies | 38 view(s)
3 Hours Ago
zalhaj
replied to a thread
What part of the world do you live in??
in
Lounge
Hot & Humid all year long. Kingdom of Bahrain
see more
722 replies | 565406 view(s)
3 Hours Ago
SiriusC1024
replied to a thread
Why is idle timing so much lower than 4 tables?
in
GM V8 Tuning - Engine, Gas (Gen 3)
Because you're having an ignition problem, and they're cheap, and it probably needs the right ones anyway. RockAuto has NGK TR6GP (6 heat range,...
see more
33 replies | 887 view(s)
3 Hours Ago
SiriusC1024
replied to a thread
Dies in gear, no acceleration
in
GM V8 Tuning - Engine, Gas (Gen 3)
Still have to tune the VE table man.
see more
4 replies | 138 view(s)
More Activity
No More Results
No Recent Activity