I am not sure too. I just noticed it was set to 14.5, and after doing some google searching it looks like because it was running / tuned to 95? Most...
Since there were multiple springs that had matching dimensions I didnt think to measure them, I checked to make sure it matched up to another valve's...
Have you guys ever seen this in the log files and is it something I should diagnose? I just noticed it in the last couple mild to heavy load pulls I...
It's the alcohol multiplier table. That's what multiplies against the density. Quick and easy thing to do is to put the same one in that the SD side...
Since there were multiple springs that had matching dimensions I didnt think to measure them, I checked to make sure it matched up to another valve's...
Do you know what the stock values for 44373 and 44374 should be? These values have not been changed. But this is an "aftermarket" ECM. It is a stock...
just to make sure. under fuel>general>and then under flow rate.is that the correct density multiplier, do i just times the whole table by 1.30? also...