Register
Help
Remember Me?
What's New?
Activity Stream
New Posts
New Events
Mark Forums Read
Forum
Advanced Search
Home
Activity Stream
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
6 Minutes Ago
DobermanRacing
replied to a thread
Tuning MAF and VVE at the Same Time
in
GM V8 Tuning - Engine, Gas (Gen 4)
I've been struggling to find (maybe understand) applicable filters for Gen V. I've been using TitanTuned filters. MAF DYNAMIC AIR OPEN LOOP ...
see more
225 replies | 37827 view(s)
22 Minutes Ago
gtstorey
replied to a thread
I have to start over - Write Entire is SCARY!
in
GM V8 Tuning - Engine, Gas (Gen 3)
I know, but it's been 3 months. And I hate the phrase "it won't start" without clarification of crank or no crank. But he does say the logs are...
see more
37 replies | 2327 view(s)
27 Minutes Ago
edcmat-l1
replied to a thread
I have to start over - Write Entire is SCARY!
in
GM V8 Tuning - Engine, Gas (Gen 3)
I'm assuming by his post, it ran fine, they flashed it with something else, then it didn't. OP correct me if I'm wrong. PS there ain't a jumbo...
see more
37 replies | 2327 view(s)
28 Minutes Ago
edcmat-l1
replied to a thread
I have to start over - Write Entire is SCARY!
in
GM V8 Tuning - Engine, Gas (Gen 3)
I don't get it. What was wrong with the file it ran on? Have you posted both? The file it runs on and the one it doesn't?
see more
37 replies | 2327 view(s)
38 Minutes Ago
edcmat-l1
replied to a thread
5.3 Swap Starts then Dies
in
GM V8 Tuning - Engine, Gas (Gen 4)
Need a fuel pressure gauge on the vehicle at all times. Preferably one you can view from the driver's seat while operating the vehicle. You need...
see more
2 replies | 29 view(s)
53 Minutes Ago
gtstorey
replied to a thread
5.3 Swap Starts then Dies
in
GM V8 Tuning - Engine, Gas (Gen 4)
Need to post the tune also.
see more
2 replies | 29 view(s)
54 Minutes Ago
gtstorey
replied to a thread
I have to start over - Write Entire is SCARY!
in
GM V8 Tuning - Engine, Gas (Gen 3)
Have you checked the basic of why it won't start? I assume you mean it will crank but doesn't start. Are you getting spark? Fuel? Too much Fuel?
see more
37 replies | 2327 view(s)
1 Hour Ago
JumboShrimp
replied to a thread
I have to start over - Write Entire is SCARY!
in
GM V8 Tuning - Engine, Gas (Gen 3)
Well, I'm back. I got all my work done - new adapters, Hood intake clearance fixed, LS7 Card MAF in a 4" tube, Re-Plumbed the HX, Wrote Entire (The...
see more
37 replies | 2327 view(s)
1 Hour Ago
angelm_ix
started a thread
5.3 Swap Starts then Dies
in
GM V8 Tuning - Engine, Gas (Gen 4)
Hey all. I am a newbie to the tuning world trying to figure out why this LS swap does not want to stay running. It is a 2007 LMG going into an '81...
see more
2 replies | 29 view(s)
1 Hour Ago
edcmat-l1
replied to a thread
New engine and 4l60e combo, slipping in 4th
in
GM V8 Tuning - Engine, Gas (Gen 3)
Yes, at idle, not moving, the TCC slip should be same as your idle speed. 1500-1700 @ 5200, part throttle sounds a bit much. The same slip at...
see more
20 replies | 437 view(s)
1 Hour Ago
HourlyB
replied to a thread
2016 Mustang GT Manual stock tune
in
Ford Tuning - Engine, Gas (Non Ecoboost, US)
I dont have the stock tune, it was done by a shop and they don't have it any more. I assume I will need to buy a MPVI3 to open the Lund tune?
see more
2 replies | 186 view(s)
1 Hour Ago
Psmith1024
started a thread
My Camaro now has Auto Stop
in
GM V8 Tuning - Engine, Gas (Gen 5)
I've run into a little issue after getting my 2020 Camaro SS (manual transmission) back from the tuner. Twice now, the car shut off at a stop and I...
see more
0 replies | 64 view(s)
1 Hour Ago
Doss188
replied to a thread
8 to 1 Headers and 02 sensors
in
GM V8 Tuning - Engine, Gas (Gen 3)
Thanks for the reply, that looks like what i was looking for.
see more
5 replies | 76 view(s)
1 Hour Ago
edcmat-l1
replied to a thread
Surging and LTFT questions on LS1
in
GM V8 Tuning - Engine, Gas (Gen 3)
The one log where it does have a good amount of idle roll, it's in open loop (so it's not trims causing it in that log), the spark is barely wavy,...
see more
4 replies | 88 view(s)
2 Hours Ago
TheMechanic
replied to a thread
Operating OS's 1250216 & 1250219 compatibility
in
GM V8 Tuning - Engine, Gas (Gen 4)
"without bricking it". No such thing. You take a risk every single time you program. Something can always go wrong. Battery voltage, laptop,...
see more
4 replies | 151 view(s)
2 Hours Ago
SiriusC1024
replied to a thread
8 to 1 Headers and 02 sensors
in
GM V8 Tuning - Engine, Gas (Gen 3)
Yeah and wiring. https://lowbuckls.com/closed-loop-with-one-o2-sensor-using-the-stock-ecm/
see more
5 replies | 76 view(s)
2 Hours Ago
TheMechanic
replied to a thread
8 to 1 Headers and 02 sensors
in
GM V8 Tuning - Engine, Gas (Gen 3)
So you run them all zero and only look at the B1S1?
see more
5 replies | 76 view(s)
2 Hours Ago
TheMechanic
replied to a thread
8 to 1 Headers and 02 sensors
in
GM V8 Tuning - Engine, Gas (Gen 3)
Pretty much two options. 1. Run an O2 in a left and right bank primary tube. It will only get fuel control from THAT cylinder. Not a great...
see more
5 replies | 76 view(s)
2 Hours Ago
SiriusC1024
replied to a thread
8 to 1 Headers and 02 sensors
in
GM V8 Tuning - Engine, Gas (Gen 3)
You can run just one and adjust Fuel>General>Injector Bank Select to match.
see more
5 replies | 76 view(s)
2 Hours Ago
davus
replied to a thread
Tuning 2010 rxt 260
in
BRP
Hello everyone. Just to close the loop in this thread. You cannot use a straight through adapter cable for BRP. The cable I had was a perfectly...
see more
8 replies | 513 view(s)
2 Hours Ago
davus
started a thread
Tune Repository
in
BRP
Hi folks. Had a look through the posts and couldn?t find anything in this. I notice that with all the other supported brands / models, there are...
see more
0 replies | 22 view(s)
2 Hours Ago
HartRod
replied to a thread
MPVI2 (and 2+) prolink and AEM CAN bus
in
VCM Scanner External Sensors
Any luck?
see more
31 replies | 11657 view(s)
2 Hours Ago
Alvin
replied to a thread
Surging and LTFT questions on LS1
in
GM V8 Tuning - Engine, Gas (Gen 3)
LTFT's can "stick" positive and run the WOT fueling rich. STFT's or LTFT's are not updated during PE, and you should be in PE at 100kPa or slightly...
see more
4 replies | 88 view(s)
2 Hours Ago
abc
replied to a thread
New engine and 4l60e combo, slipping in 4th
in
GM V8 Tuning - Engine, Gas (Gen 3)
10-4 Alvin, that's great advice! Ed, No, it's not a multi disc TCC. I'm not locking it up under heavy load. I understand now after reading my...
see more
20 replies | 437 view(s)
2 Hours Ago
briantr2
started a thread
Dodge hellfirre cam settings
in
Dodge Tuning - Miscellaneous
I am getting a 5.7 with a hellfire 2 CAM running , do i lock the cam at 120 and go my 8 degrees from there
see more
0 replies | 18 view(s)
3 Hours Ago
Doss188
started a thread
8 to 1 Headers and 02 sensors
in
GM V8 Tuning - Engine, Gas (Gen 3)
Hello, I am building a rat rod and using a 2004 chevy 5.3 motor. I am planning on running an 8 to 1 header set up. I am trying to understand what...
see more
5 replies | 76 view(s)
3 Hours Ago
abc
replied to a thread
Surging and LTFT questions on LS1
in
GM V8 Tuning - Engine, Gas (Gen 3)
whoops... Injector Dynamics ID1050X
see more
4 replies | 88 view(s)
4 Hours Ago
cjautomotiverepair
replied to a thread
4l60-4l80 swap
in
GM V8 Tuning - Engine, Gas (Gen 3)
I'll dm you Os - 01253052
see more
2 replies | 64 view(s)
4 Hours Ago
bkg06gto
replied to a thread
Strange 1-2 shift behavior 22 Mach 1
in
Ford Tuning - Engine, Gas (Non Ecoboost, US)
Awesome, I?ll start there. Looked into this one as a favor, i deal mostly with GM stuff and the gen V stuff has some same ideas but as we know way...
see more
4 replies | 66 view(s)
More Activity
No More Results
No Recent Activity