Register
Help
Remember Me?
What's New?
Activity Stream
New Posts
New Events
Mark Forums Read
Forum
Advanced Search
Home
Activity Stream
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
1 Minute Ago
Brendon
replied to a thread
Racerender suddenly doesn't recognize HEVC codec
in
RaceRender
Racerender is now working properly again. Success, if only temporary, Lets see. I did a windows roll back. Control Panel / Recovery. Open system...
see more
15 replies | 2497 view(s)
1 Minute Ago
Seishuku
replied to a thread
Power Enrichment Issue On 2.0 Ecoboost Swap
in
Ford Tuning - Engine, Gas (Ecoboost)
Try zeroing 44815, set vehicle speed limit to 0.0 in 44775, set the same entry in 33458 to 1.0, and maybe put 44373/44374 back to stock? I'm pretty...
see more
3 replies | 96 view(s)
1 Minute Ago
Brendon
replied to a thread
Win 11 - Only Audio Track loaded | HEVC
in
RaceRender
Racerender is now working properly again. Success, if only temporary, Lets see. I did a windows roll back. Control Panel / Recovery. Open system...
see more
10 replies | 515 view(s)
11 Minutes Ago
04silverado6.0
replied to a thread
Blue cat question on shift speeds
in
GM V8 Tuning - Transmission
Here is a 06? 1500hd i tuned for example.
see more
3 replies | 17 view(s)
13 Minutes Ago
04silverado6.0
replied to a thread
Blue cat question on shift speeds
in
GM V8 Tuning - Transmission
The 4l80e has a very tall first gear. Those speeds sound reasonable depending on the axle ratio, tire size, rpm. They set the shift speeds way low in...
see more
3 replies | 17 view(s)
15 Minutes Ago
04silverado6.0
replied to a thread
Stock truck with VVE off by more then 10%????
in
GM V8 Tuning - Engine, Gas (Gen 5)
Disable ltft and dfco. Get a log and see how it looks.
see more
1 replies | 90 view(s)
17 Minutes Ago
tylervalo
replied to a thread
Base C5 tune needed
in
GM V8 Tuning - Engine, Gas (Gen 3)
Thank you, yeah i did have all the channels and graphs setup already I just couldn't get the EGR turned on to get the PCM reporting any voltage.
see more
14 replies | 298 view(s)
17 Minutes Ago
BigSloth
replied to a thread
EEC-V Support
in
Ford Tuning - Engine, Gas (Non Ecoboost, US)
Eric, how does one get this MPVI3 firmware for the EECV logging, I had a support ticket open the other day for a 03 Lightning and we found the rev...
see more
12 replies | 815 view(s)
23 Minutes Ago
Subcool
started a thread
15 Silverado 5.3 to 6.2 Swap Questions
in
GM V8 Tuning - Engine, Gas (Gen 5)
This is my first time, I'm here to listen and learn. I just finished dropping a 6.2 in a buddy's 2015 Silverado, which was previously a 5.3. It...
see more
0 replies | 5 view(s)
27 Minutes Ago
hjtrbo
replied to a thread
Blue cat question on shift speeds
in
GM V8 Tuning - Transmission
Verify driveline input information and tyre size
see more
3 replies | 17 view(s)
30 Minutes Ago
hjtrbo
replied to a thread
E67 GMPP - What is RedPw
in
GM V8 Tuning - Engine, Gas (Gen 4)
reduced power
see more
1 replies | 10 view(s)
30 Minutes Ago
hjtrbo
replied to a thread
2010 VE LS3 Manual Tune.
in
GM V8 Tuning - Engine, Gas (Gen 4)
Australia / New Zealand use a different octane rating system than you guys over in the States. Our 98 is equivalent to your 93. And to the OP,...
see more
6 replies | 139 view(s)
34 Minutes Ago
lewma
started a thread
E67 GMPP - What is RedPw
in
GM V8 Tuning - Engine, Gas (Gen 4)
All I have an AimSport PDM32 hooked up to my E67 GMPP. ECU is providing a "RedPw" channel as part of the canbus data coming from the ECU. Any...
see more
1 replies | 10 view(s)
37 Minutes Ago
blindsquirrel
replied to a thread
Need help with 07 TBSS clutch fan settings
in
GM V8 Tuning - Engine, Gas (Gen 4)
Oh, if you get the scanner controls right and the fan is working, you will know it for sure because it will sound like... well, like a big 19"...
see more
36 replies | 829 view(s)
41 Minutes Ago
blindsquirrel
replied to a thread
Cool new Porsche 911 hybrid. Tuned to always run lambda 1 with no power enrichment.
in
Lounge
Current-gen F1 V6 (yuk) turbos run 18:1 CR (rules-limited), 5.5 BAR boost ("or more"), at 1.3-1.4 Lambda.
see more
1 replies | 25 view(s)
50 Minutes Ago
GHuggins
replied to a thread
E85 PE question
in
GM V8 Tuning - Engine, Gas (Gen 5)
I would highly advise going back to gas and verifying your fueling to be 100% there, but until you update that density multiplier for the 30% extra...
see more
35 replies | 1036 view(s)
55 Minutes Ago
GBull
started a thread
Blue cat question on shift speeds
in
GM V8 Tuning - Transmission
I have used the Blue Cat trans program for my 01 silverado 6.0l 4l80e. After seeing the results I am questioning the shift speeds that have been...
see more
3 replies | 17 view(s)
56 Minutes Ago
hjtrbo
replied to a thread
e38 bbc idle surge with ac on
in
GM V8 Tuning - Engine, Gas (Gen 4)
Idle torque around the 30Nm mark is good for most. If you can hunt around for a stock tune for your OS you'll be able to see if it's already been...
see more
7 replies | 174 view(s)
57 Minutes Ago
yevgenievich
replied to a thread
e38 bbc idle surge with ac on
in
GM V8 Tuning - Engine, Gas (Gen 4)
Looking at the log again, at idle it is running speed density until 2500 rpm when maf comes in. This was done to try and fix the lean lag that is...
see more
7 replies | 174 view(s)
59 Minutes Ago
hjtrbo
replied to a thread
e38 bbc idle surge with ac on
in
GM V8 Tuning - Engine, Gas (Gen 4)
^^^ +1
see more
7 replies | 174 view(s)
1 Hour Ago
CNash729
replied to a thread
2020 L87 L84 stock file?
in
GM V8 Tuning - Engine, Gas (Gen 5)
Here is a stock file
see more
1 replies | 412 view(s)
1 Hour Ago
Shari25
replied to a thread
Wiring diagram For a ProLink+
in
All MPVI Interfaces
Is it possible to find such a diagram on the official website?
see more
2 replies | 576 view(s)
1 Hour Ago
TheMechanic
replied to a thread
2010 VE LS3 Manual Tune.
in
GM V8 Tuning - Engine, Gas (Gen 4)
I've seen stock reads with different stoich. I always figured that it had something to do with the ethanol content in fuel now. Can't get any...
see more
6 replies | 139 view(s)
1 Hour Ago
realspeeddan
started a thread
Retrieving device code from class already taken a while ago. For parameter access.
in
VCM Editor
I took the class more than a year ago to unlock parameter access. Can I retrieve that code from somewhere and re-enter it? I've switched...
see more
0 replies | 12 view(s)
1 Hour Ago
DustinG
replied to a thread
completely lost here
in
GM V8 Tuning - Engine, Gas (Gen 5)
A professional tuner I definitely am not but I agree with this 100%. Just the tq tables alone are way off.
see more
4 replies | 297 view(s)
1 Hour Ago
Advobeast
started a thread
Missing tabs in VCM editor
in
Ford Tuning - Engine, Gas (Non Ecoboost, US)
Anybody else see this? I have a 2016 Mustang gt PCM that doesn't have the same tabs as a 15 or 17. For example: I do not have an...
see more
0 replies | 13 view(s)
2 Hours Ago
TheMechanic
replied to a thread
PCM swap
in
GM V8 Tuning - Engine, Gas (Gen 3)
If it is a like for like for like then yes a relearn is all that is required.
see more
1 replies | 598 view(s)
2 Hours Ago
fst100
replied to a thread
3800 tuning help
in
VCM Editor
you may need to get the pcm from the 03 maybe? https://forum.hptuners.com/showthread.php?32518-3800-engine-swap-question&p=243786#post243786
see more
2 replies | 60 view(s)
2 Hours Ago
fst100
replied to a thread
P1810 Code After Engine/Trans Swap - 00 to 04 Programming Help Needed
in
GM V6 Tuning - Transmission
did you see post #9 in the 3800 link by chance?
see more
2 replies | 5965 view(s)
2 Hours Ago
snowedin
replied to a thread
Wastegate Fluttering and Lurching above ~50% 2018 2.3L EcoStang
in
Ford Tuning - Engine, Gas (Ecoboost)
I've been able to get pretty consistent pops and noise on downshifts/hard cuts, only appearing so because of how I modified the spark tables. Is...
see more
10 replies | 624 view(s)
More Activity
No More Results
No Recent Activity