Acceleration Threshold

[INTHERED]

On a C6 Z06 there is an Acceleration Threshold table listed under Fuel Cutoff / RPM Limits / Accel Thres that I have attached as a JPG. Does anyone know how this table functions especially the units across the top that range from 0 to 1000 ? Could this table reduce power on the dyno above 6500 rpm ?

Thanks >>>>> Inthered

[BBA]

Everyone pretty much sets it to zero. (I did as well).

It limits the rate of accelleration, not at a specific RPM but RPM below the current limit.

[INTHERED]

Everyone pretty much sets it to zero. (I did as well).
It limits the rate of accelleration, not at a specific RPM but RPM below the current limit.

After some additional investigation it appears that the table below it the RPM Limit Max Accel vs. Gear turns off acceleration based limiting since its set to only limit above 8192 rpm in gear.

Do you do anything to the Cmd Torque Delta table listed below the Accel Based tables ?

Thanks >>>>> INTHERED

[Joe_G]

On a C6 Z06 there is an Acceleration Threshold table listed under Fuel Cutoff / RPM Limits / Accel Thres that I have attached as a JPG. Does anyone know how this table functions especially the units across the top that range from 0 to 1000 ? Could this table reduce power on the dyno above 6500 rpm ?

Thanks >>>>> Inthered

I had a false rev limiter at 5200 in 2nd gear when I put in 3.90 gears until I zeroed this table. That fixed it.