I think that is my problem EC tune,,,I now have the MAF enabled and I am logging. But I don't think I am logging as you describe with MAF HZ on the table view.
I am not sure how to go about that. I did manage to log LTFT's and like I said, it was lean everywhere. My problem is, I cannot figure out how to apply the LTFT histogram to the MAF Table,,,because the MAF table is a long skinny table that is not setup like the VE table is.
It was simple to do the VE table, you could go box to box if you had to,,,very simple. But the MAF table is not setup like this.
Since the MAF table is long and skinny and I cannot tell which block needs attention,,,I took an average from my LTFT,,,(in this case I took 8%) and I just added 8% accross the entire MAF table for giggles. Another datalog of LTFT's and now some of the blocks are too rich
I wish there was a MAF table similar to the VE table so it would be easy to transfer the info.
There has to be something stupid I am missing here.
Larry.