-
Potential Tuner
coyote throttle body issue
Gen 1 Coyote swap. I had a no start before due to the crank pulse wheel not being there. No idea where that damn thing went because I have a picture at one time where it was there. But we had the engine and trans in and out numerous times when we were building this thing so I guess the dog ate it one of those times. Now it fires off but won't stay running. The thing that stands out is that I'm not seeing the throttle body move. I see the commanded go up with the pedal press. And I'm almost positive I could hear it snap shut key on not running before. But I'm not seeing TPS% change now with the pedal press. If I disconnect the throttle body everything goes wonky and I don't get anything. So it sees it. Where would I start trying to troubleshoot it? Could a TB go bad on one of these?
-
Pull a simple log with a torque source and post it here.
-
Potential Tuner
All good now. Reloaded the copperhead calibration and voila I could hear the throttle body actuate. Cranked right up. It's a bit rough due to the non stock intake. But a place to start!