Need help with 2018 Coyote Gen3 5.0 tune

[coach36]

I couldn't. I had to take them out because of the space to the firewall.
Can you help me with those settings or point me the right way?

[engineermike]

I did a gen2, but I think the gen3 is the same. It would appear as though disabling imrc in the imrc tab and/or disabling all the imrc-closed mapped points would do it, but nothing simple I tried worked. In some cases it still used the closed mapped points and in others it seemed to work ok except it wouldn’t allow knock advance. Note that if it senses an imrc error it might not trigger a DTC but it won’t allow knock advance.

I basically had to transplant all the calibration data (torque, speed density, borderline, and knock) from the imrc open mapped points over to the closed mapped points with the same cam positions. It was a tedious task but that’s the only way I could make it work properly.

[coach36]

oh boy...
well, do you have or remember what to change? I really need your help with this.

[coach36]

is this here where this goes?:
https://forum.hptuners.com/showthrea...on-Information

[engineermike]

2008 was pre-mapped points.

[coach36]

OK, so i tried the setting to get the pops etc, but nothing

[engineermike]

Try 0.0 for the tr spark only number. Btw it should only burble for a second or less when you let out by using this method.