Hey Guys,
I am looking for help with my speedo dropping out at 100mph. I have an E67 with LSA in a 2nd Gen Camaro. The E67 and FSCM are the only GM controllers in the car.
I have read a few posts on this topic (including
[email protected] "sticky" posts) and they state:
"Go to SPEEDO, LIMITER tab. Under GENERAL change the Source from GMLAN to Calibration. Under LIMITS, change Speed Limit Comm Fail to the desired speed."
Per the screen shot attached, I set the Source to [Calibration] and increased all the limits to [194/318]mph.
The speedo still drops to 0 at 100mph (the scanner's [Vehicle Speed] trace also drops).
Speed Limiter.png
Looking for help to fix this issue. I used [Write Calibration] when I flashed the controller (not [Write Entire]). My Vehicle Speed Output is also set to [Serial].
I appreciate any feedback.
Thanks!
Jeff