-
Potential Tuner
Help with AEM 30-0310
Hi all I am definitely new to all of this and any help would be greatly appreciated. I recently installed a AEM 30-0310 wideband sensor and I cant for the life of me figure out how to make everything work together. I watched a few videos and it helped a little but nothing seems to be working. No matter what I do all I can get it to read is between 18.3 and 18.6 and it doesn't matter if its in the exhaust or not which is kind of telling me I have it all set up wrong. The aem sensors that come preinstalled in the hp tuners software don't seem to work and I cant seem to figure out how to adjust everything to get it right. Any help would be greatly appreciated. Thanks in advance.
-
Are you using the analog or serial output on the 0310, and what do you have it connected to?
-
Potential Tuner
I?m using the serial outport and it?s connected to the 5v outport. So basically It?s connect to the number 1 pin on the serial port and then I have the ground on the number 5 pin on the serial port.
-
Should be RX to pin 2, GND to pin 5.
20190524_235958.jpg