Just finished Cam install. Brian Tooley comp cam. Installed dual comp valve springs, pushrods, trunion upgrade.
cam specs: LS1/2 Stage II Cam 227/234 .614"/.576" 113+2
I dialed in the MAF. I have not tried doing the whole speed density tune yet. I enabled SD tuning and it runs super rich. Also Im not sure how to make changes to the VE table with what im getting from the histograms i am logging. Plus it seems like i need to change the VE before i drive in SD mode. It does not run well at all and around 10.5:1 AFR.
So ive copied and pasted VE and spark tables from a similar tune setup on the repository.
Ive also logged some light driving. Experienced some knock but only a couple degrees. I have DFCO turned off on this Log. can someone please look at the tune and log and give me any advice please?
I wanna go fast!
PS it is an 04 GTO engine and t56 swapped into a RX7 fc. cam 1 idle fix with repository ve and spark.hptcam wth repository ve and spark.hpl