Can this be added to the tuning package? It would be nice to be able to use this to enter PE whenever you want based on load.
Can this be added to the tuning package? It would be nice to be able to use this to enter PE whenever you want based on load.
which year?
I count sheep in hex...
2003 Envoy. I dont think it is in the 2002 file either.
i think you'll find it's already in there, although it's not load, it's TPS.
PE Enable TPS vs RPM
I count sheep in hex...
Ok chris, i see that now. Thank you. There must be some other checks in there as well as i cannot enter into PE mode at low rpms with little throttle even while changing the TPS enable %. Must be some time and speed restraints of some sort. Thanks again.
im assuming you have & have lowered the delay rpm table?
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Yes i have. I have lowered all required tables and could not enter PE any sooner than before modifing the PE tables.
I would say send your file/info log to support along with your issue...chris should be able to find & apply your fix.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Reply With Quote