What causes this TQ Mang. I need help.

[Ecotec2.4]

I bought a book and I'm trying to learn this stuff.
What TQ Managment is pulling timing at each shift ?
What cause the commanded afr to go rich for a little bit ?

I thought all TQM was removed on this tune, hmmmmm
07 LE5 2.4L Auto 11psi E67ecm T42tcm
Thanks in advance for any advice !
TIMING,AFR SWINGS.png
log of above
ROS4-11P.hpl
tune
ROSWELLtry1.hpt
config.
RBnew-1.cfg

Thank You !

[Ecotec2.4]

Wow
I guess there is no love for us red hair'd step children on this forum !

I could of had a V8, but I chose 4 cylinders, my baddddddddd I guess

[ScarabEpic22]

Theres still TM in that tune on the trans side.

Trans->Torque Management-> Torque Reduction (section). Pattern X and Downshift have TM left in, I would imagine that's where it's coming from as Pattern X is the only one that's set to be used in your tune.

Also, not sure if you want/care but setting Engine->TQ Mgmt->Brake Torque Management ->Disable by TCS to Enabled will remove any BTM events if you turn TC/ST off.

[Ecotec2.4]

THANK YOU sooooooooo very much !

I'll give that a try this weekend.

Thanks again.

[ScarabEpic22]

Sure thing, report back if that fixes it or not!

[Ecotec2.4]

Got it done this morning.
TQREMOVE.png
Much better, Thank You !
That is like 9/10ths of a second difference from 25-85 mph at 6psi.

Now on to maf low to get it a bit closer, then wot, that wot fueling is off by A LOT !
Looks like I need to lower wot timing a bit till I get the fueling correct.

Thanks Again for your help and advice,
Much Appreciated !

[ScarabEpic22]

Definitely not getting any timing pulled now!

Get that WOT fueling dialed in and it'll look even better.

[Ecotec2.4]

We will be wot tuning this weekend, weather permitting !

Thanks again for your time !