-
Potential Tuner
-
HP Tuners Owner
it doesn't look like you are running speed density mode.
You need to fail the MAF or unplug it. Set P0102 & P0103 to "2 - No MIL"
-
Potential Tuner
I'll do that first thing after work! I didn't think it was an issue since I'm not maxing out the maf. Thanks for the help!.
-
Tuner
I tried to unplug the MAF one time and the check engine light came on and the vehicle barely ran so I had to stick with "failing" it. But it still showed that it was reading normal air flow on the datalogger. Not sure if I set up the P01012 & P0103 up correctly though.
-
Potential Tuner
I tuned a turbo cts-v and it didn't have an issue with going into boost enrichment. We ended up taking the maf out after we started maxing it out. I set it to no mil and no error reporting. Is this wrong?
-
Senior Tuner
You need to set P0102 & P0103 to "2 - No MIL"
If you have no error reporting in will not enter SD
-
HP Tuners Owner
you must have codes P0102 or P0103 set for the PCM to run SD.
Set them both to "2 - No MIL".
To set these code you either unplug the MAF (sets P0102) or change the MAF Fail Frequency to 0 (sets P0103).
-
Potential Tuner