New to tuning just got the HP Tuner & the Tuning school manuals. Have been reading, trying to learn how to things work. I ordered the Greg Banish books yesterday to see if they would help.
I have included the tune and a couple scans on a 2011 Camaro 7.0L 6spd auto with a Kenne Bell 3.6 supercharger. The car loads up at idle after warm up, the trans drags out the shifts & flares upshifts with the paddles. It seems like it hits the rev limiter on upshifts in auto. The owner says it is worse with the traction control on, but I looked in the tune and it appears to be disabled?
I do not have a wideband O2 yet, I know I need that so I can get the AFR readings. At this point I am just looking at the tune and trying to make some scans to get familiar with the tuner. I tried to make a boost PID following the steps in the manual, but it did not work, it also messed up the map reading. I see others on the forum had the same problem. I also tried some of the function strings off from the forum, but got a parameter not supported error.
Anyone care to look at the tune and scans and give some input?