Can someone please post a config file that will work on an 06 corvette with an aem wideband. I cant seem to make any config that i have tried work so far. It tells me that the histogram is not supported even though i am logging the pids and sensors. Now at the bottom of the table where its says wideband-aem the air fuel does show up but just not in the histograms. Can someone please help me???
Last edited by z06Hunter; 11-18-2009 at 10:07 PM.
Man guys I really need ur help!!! I'm pulling my hair out trying to get this thing to log correctly!!!
By the way this is an 06 corvette with a 427 lsx and a twin 67mm custom sts turbo kit. Lonnies performance twin intank setup with 120lb injectors!!!
Last edited by z06Hunter; 11-19-2009 at 07:58 AM.
if your logging the wb correctly, your histo is not setup right.
im using the aem wb and it works fine. i use lambda, see if this works for you, but i doubt it.
try opening the scanner and pressing F1 to read the help..
Last edited by carlrx7; 11-19-2009 at 08:10 AM.
Are you using EIO/Pro or are you piping the wide band signal through the AC or EGR?
Bill Winters
Former owner/builder/tuner of the FarmVette
Out of the LSx tuning game
Thanks I'll try that config. Again my wideband shows up on the table screen at the bottom and it's actually a little bit diff than what's showing up on my wideband gauge itslelf but that's a diff story...lol
yes I am using the eio pro dongle.
Hey 5liter eater u helped me with setting up my config a couple of years ago on my z06 thru the ac if u remember.
If Carl's config doesn't work for you then post up your current config. Are you using a user defined EIO PID for the AEM or the built-in one?
Bill Winters
Former owner/builder/tuner of the FarmVette
Out of the LSx tuning game
I'm using the built in one. Should I be using a user defined one?
Well Carl's did not work unfortunately. Here mine. Maybe i have something set up wrong.
you need to add "air fuel ratio commanded" to the table. There is a lo res and hi res PID. I recommend lo res as it takes up less bytes. Without logging the commanded AFR the AFR Error PID cannot do it's calculation.
Bill Winters
Former owner/builder/tuner of the FarmVette
Out of the LSx tuning game
thank you buddy. After hours and hours of trial and error i finally figured it out the other day...lol And you have a pm from me buddy.
here is my tune and log 5 liter eater
Reply With Quote