Need histogram for inj duty cycle in boost

[SBerry]

Just switched to 2-bar os. and logging to set VE tables
Inj duty cycle chart only goes to 105kpa
Cant find one for boost in the forums
Dont know how to write one
Please help

Scan of inj duty cycle is 95 at 105kpa
I think I will need a better fuel system


Mods are:
05 gto stock motor with cam
maggie 112 5-psi with magna volt
kook headers with SLP
Spec 3 clutch
with maggie tune 12.50 1/4 mile at 113mph

[5_Liter_Eater]

I don't see why you would need to plot IDC against the MAP. If you're out of injector id don't matter what MAP it happens at. I have an IDC chart on my dashboard with a warning set at 90%. Then you could add it to the chart display so you can see where it maxes out and at what RPM/MAP.

[SBerry]

Thanks for the reply. I just wanted to know what the duty cycle was in boost. My afr was still good. I was commanding 11.4 at wot but my wideband was at 10.3. I still need to adjust the ve table. I am just getting started on this tune. Thanks again

[SBerry]

The idc was 95 at 6600rpm
What is the max idc to run

[shabby]

I remember running like 130% duty cycle on my dsm for years

[S2H]

Safe max is 80%
Above that you should get bigger injectors

Anything above 100% means the injector is wide open....

[SBerry]

I just figured out how to make a histogram for boost IDC
Here it is if anyone cares