cant speed density tune after cam install

[Z107]

i have a e38 camaro m6 with a newly installed tsp bald eagle cam, some dual springs, and pushrods. when i apply the paramenters to turn of ltft and get into speed density my engine will not stay alive. dont want to screw up the tuning so tell me if i did everything right here and if so why will my eninge not stay running.



Duration 0.50 229/242
Love lift 0.353 0.353
Valve [email protected] .600 .600
Lobe seperation 112
Intake center line 109


speed density.hpt


im grabbing a log as i post this will follow up shortly

[Z107]

speed density death.hpl

[Lakegoat]

Here is what I would do. Engine diagnostics--airflow--P0068--change to 8000 rpm
Under DTC's---P0101,102,103--change to Mil on first error and uncheck the boxes
Engine --airflow--dynamic--dyn airflow--Disable 8000---Reeneable 7900
Idle--airflow--Base running airflow--250,400,600,800,1000 columns, add 2.00 to all
Spark--Idle adaptive spark--P/N, Gear and Coast---make the numbers from 96 to the end -8 instead of -24. Underspeed---same as above except make the number 10 in all three charts
Should run if you didn't change injectors