managed to get a full pull but boost seems to want to settle down around 12-15psi depending on load
managed to get a full pull but boost seems to want to settle down around 12-15psi depending on load
384whp/303wtq
Built 2.0LSJ: TVS w/2.6, 1000cc, Stage 2 cams, custom fuel system, E85, Dual Pass, 3"intake, 3" Catless exhaust, CIA midlength Header
its not all
Screenshot_11.jpg
try it
VW 2013 F150FX4 Ecoboost - SCT HPP - speedo_final gear adj 3nd.hpt
is possible to log air load and desired air load?
ill give it a shot! really appreaciate your help btw!
384whp/303wtq
Built 2.0LSJ: TVS w/2.6, 1000cc, Stage 2 cams, custom fuel system, E85, Dual Pass, 3"intake, 3" Catless exhaust, CIA midlength Header
made the recommended changes and seems to be doing a bit better
tell me what you think? i still have 1-2 deg of knock that i need to pull out as well
384whp/303wtq
Built 2.0LSJ: TVS w/2.6, 1000cc, Stage 2 cams, custom fuel system, E85, Dual Pass, 3"intake, 3" Catless exhaust, CIA midlength Header
Need to take out all duplicate
Screenshot_13.jpg
i see, ltb lean before WOT, at WOT is ok.
Screenshot_12.jpgScreenshot_14.jpgScreenshot_15.jpg
is possible to monitoring WB 1 and WB 2 lambda?
and your IAT ltbt high, stock intercooler?
is possible to post stock tune?
Screenshot_16.jpg
Now you have good load, need only adjust gently
Last edited by kel83; 09-08-2021 at 08:03 AM.
ok so a few things here that i need help with as I am trying to learn this better:
1. Base fueling: what table to help correct fuel? I went for a pretty extended drive and ran errands leaving the truck running to hit as many cells as possible. I am logging wideband EQ% Error to hopefully fix some of the lean & rich spots in the map. what table, as they all seem to be ACT vs ECT based/?
2. Torque/Pedal: Im not understanding the Driver Demand Torque Table. What would/should I log in order to tune this table? %error?
3. Spark: I want to learn this stuff but i am not sure what table to make changes to add/remove spark timing. Do i apply the same %mult from the knock log to all 13-14 spark tables? or seek out what mapped point knock occurred?
i feel like my entire approach to logging for %specific errors in histograms may be misguided on the Ecoboost...
384whp/303wtq
Built 2.0LSJ: TVS w/2.6, 1000cc, Stage 2 cams, custom fuel system, E85, Dual Pass, 3"intake, 3" Catless exhaust, CIA midlength Header
384whp/303wtq
Built 2.0LSJ: TVS w/2.6, 1000cc, Stage 2 cams, custom fuel system, E85, Dual Pass, 3"intake, 3" Catless exhaust, CIA midlength Header