Hi everyone..!

My 2005 A4 Z51 C6 is going to the garage tomorrow for the installation of a few mods.. It'll take about a week or so to complete the installation of all parts! I have currently worked on a start-up tune based on my mods.. This is my first time modding a car and my first time using HP tuners.. I have found a wealth of information on this great forum thanx to all you guys..

I was just wandering if anyone could provide me with key-points I should keep in mind before uploading the tune to my ECU.. I'm at work now but will post the tune later. Also, could anyone upload a tune that is somehow similar or close to what my tune should be based on my mods (G5X3 on an LS2 or any other similar CAM, etc.. The more the merrier!)!? ... The mods I'll be installing (stage 1) are as follows: -

Application (2005 A4 Z51 C6, 3.15 gears, stock 4L65e trans)

1. Halltech stinger SSM
2. Halltech stinger CAI (Induction Option)
3. LGM LT Pro Headers (Catless/offroad)
4. LGM 3" X-Pipe
5. LGM G5X3 CAM @ 114 LSA
6. SLP 25% U/D Pulley
7. vigilante 3500 TQ Converter
8. TransGo Shiftkit
9. B&M 24k Tranny Cooler
10. Upgraded valvetrain (Patriot Gold spting kit + 7.400 Hardenned pushrods, etc..)
11. Borla Stinger Cat-back exhaust (Quad-Round)



The car dynoed 330/343 in the middle-east's hot & humid summer..