What is needed to properly run an 2018 L83 on an engine dyno (no trans/tcm, bcm?)
First time attempting this, so please excuse my lack of knowledge. It appears as simple as getting a harness and ecm. Disabling VATs and any codes that pop up. Has anyone done this and been successful? Any tips?
As far as the Chevrolet Performance LT engines go we needed the Fuel control module and the fuel line pressure sensor even though the fuel module wasn't controlling the pump.
-Greg
2009 Maverick Silver G8 GXP M6 - 586hp
Engine Mods: TVS 2300 Magnacharger ARH 1 7/8" long tubes with catted x-pipe
Drivetrain Mods: Ram Dual Disc Clutch
Suspension Mods: Pedders/Wretched basic drag pack - BMR trailing arms
Misc Mods: Jamesbiz Catch can - GRRRR8 Heater hose relo kit
Reply With Quote