Working on my modded 2017 Zl1. I decided to try my hand at VVe tuning for the 1st time. The car was tuned MAF only when the mods were done.
Question #1 When i have my VVe tune loaded the check engine light comes as i knew it would cause of the MAF fail. However, i didn't expect the car to be in Reduced Power Mode. I read somewhere that i need to adjust tables P1514 and P0068. Is this correct?
Question #2 Being that the car is a 10spd, i am having trouble getting the higher RPM data. By default i see the VE is supposed to go til 4000rpm. During my outing last night logging and adjusting i could only get to ~2200rpm. I varied my speeds up to 60mph and at times downshifted a few gears, but still only got to 2200 and some 2400 hits. How do you do the 2200-4000 range?
Question #3 Not sure if the issue i am experiencing is due to i am using the latest Beta release as of yesterday, but after i paste special and hit the Calc Coef button some of the area will come up with some Way out of range numbers. For Example, i had 2 row block of numbers to be adjusted 10% which was fine, but when i hit the Calc button that row changed from "Lets Say" 1800 to read very high like 29000 and in some cases it went to a negative large amount. Unfortunately the undo button is grayed out after u hit the calc button so i have to exit without saving and try again. Can anyone explain how to not have it do this? It has done it more than once.
Would appreciate any insight on these 3 issues i came across.
thanks