Results 1 to 11 of 11

Thread: SD Tune off

  1. #1
    Advanced Tuner
    Join Date
    Dec 2005
    Location
    Texas
    Posts
    254

    SD Tune off

    tuned SD OL with a wideband, enabled LTFT with MAF still disconnected just to check stuff out..WOT LTFT are +5 driving AFR down to the high 11's...how am i suppose to fix this ?

  2. #2
    Супер Модератор EC_Tune's Avatar
    Join Date
    Apr 2003
    Location
    Almost 2000 feet.
    Posts
    7,876
    Why do you have LTFT's at WOT?!
    Did you disable PE?
    Always Support Our Troops!

  3. #3
    Advanced Tuner
    Join Date
    Dec 2005
    Location
    Texas
    Posts
    254
    i give up why ? no

  4. #4
    Супер Модератор EC_Tune's Avatar
    Join Date
    Apr 2003
    Location
    Almost 2000 feet.
    Posts
    7,876
    Need to look at your commanded AFR and actual AFR (if using a wideband) Hi MAP fueling is obviously high or COT enabled.
    Always Support Our Troops!

  5. #5
    Advanced Tuner
    Join Date
    Dec 2005
    Location
    Texas
    Posts
    254
    filtered to >80% throttle position


  6. #6
    Супер Модератор EC_Tune's Avatar
    Join Date
    Apr 2003
    Location
    Almost 2000 feet.
    Posts
    7,876
    Post your log & tune it helps greatly..
    Always Support Our Troops!

  7. #7
    Advanced Tuner
    Join Date
    Dec 2005
    Location
    Texas
    Posts
    254
    how ?

  8. #8
    Advanced Tuner
    Join Date
    Dec 2005
    Location
    Texas
    Posts
    254
    hold on

  9. #9
    Advanced Tuner
    Join Date
    Dec 2005
    Location
    Texas
    Posts
    254
    try this

  10. #10
    Advanced Tuner
    Join Date
    Dec 2005
    Location
    Texas
    Posts
    254
    was tuning in OLSD, i just turned the LTFT and closed loop on to see where eveything would fall....thank you for your time

  11. #11
    Advanced Tuner
    Join Date
    Dec 2005
    Location
    Texas
    Posts
    254
    car seems to run better at very throttle/ low load settings now with your tune, but i have a "Service Vehicle" light on now, also with all the tweakin i've been doin with LC1, I've dicovered it has been to the default LC1 pid and I'm using a User Defined pid, i guess that's why my readings are all messed up... set LC1 to default settings as well as using HPT defualt LC1 pid and all is well as far as the wideband goes..boy is my face red, i was getting pretty frustrated there for awhile...thanx for all the help