-
Advanced Tuner
Seem to hit brick wall on Main Fuel
Built a tune and it runs Great, nice power increase and NO Smoke
I consider it to be a mild tune as I am concerned about fuel mileage.
During data logging I noticed the Main Fuel mm3 will not go over 79.7 mm3 and I set up the main fuel table as high as 135 mm3
I also raised the Max allowed fuel as necessary as well as torque management tables
There must be something else limiting fuel delivery but I can't find it.
Any suggestions?
-
Tuner in Training
I was looking around in the code out of one of our LLY's this weekend, I think I saw another fuel quantity cap in there - I'll see if I can find it again.
-
HP Tuners Owner
that is the limit of the Main Fuel Rate PID
i need to add it as an MPID so you can scan higher values.
-
Advanced Tuner
So I am getting the fuel but I can't see it in the scanner, I can live with that for now
I suspected it might be that seemed to flat lined.
Thanks for all your hard work, You Guys ROCK
Last edited by JANNETTYRACING; 10-16-2006 at 07:13 PM.