hey guys new to the forum, i understand this topic has been beaten to death over and over and i have done a ton of searching but i feel i am very close to having this car 100% and just need some insight on where i should go from here. i have a 2000 z28 it currently has a 6.0 lq4 block bored .30 over with speed pro flat tops ls2 rods and stock ls2 crank. cam is a 235/242 111ls with +2 advance, no power adders all n/a. the car is dialed in for when it is warmed up and drives amazing but the issue i have right now is cold start, a buddy of mine who is a little more fluent with hp tuners has been guiding me but we are having quite of a time getting this thing dialed in for cold start. when i go to start it, it will start up and idle at 1200 rpm where its supposed to be for maybe 2 seconds then all of a sudden stalls right out, doesn't sputter or surge just completely shuts off. then the only way to get it started again is to pedal it until its about 1/4 of the way warmed up and i can begin to let off slowly until it wants to idle on its own. if i let off to quickly it shuts right off. we tried adding more RAF but its still doing the same thing, i even tried adjusting the friction airflow delay because it was sitting at 4 cam rev so i upped it to 100 but it still needed me to pedal it just a little bit but caught itself better than before, but when i went to put it in gear it shut right off so i set it back to 4. can someone please take a look at my tune and see where we can start? 4-5-20_freshread_after_frumusa_14_Startup_air.hpt