How do I turn the STFT off when setting up to put computer into SD mode and tuning the VE table....
This first gen computer does not have a tab for STFT disable...
How do I turn the STFT off when setting up to put computer into SD mode and tuning the VE table....
This first gen computer does not have a tab for STFT disable...
Thanks Richard
Put it in open loop
you can use this tab and raise the temp. This will keep it in opne loop, BUT, doesnt turn off o2s or stft.. Im looking for the same info
fhgghg.jpg
hey folks here you go
Max closed loop enable temp and make sure open loop fuel trims drop down is set to disabled.
You could always unplug the oxygen sensors and Clear fuel trims then start tuning with a wideband.