all good man lol - id add engine oil temp also to your channel list pids and always start your log session when it reaches operating temp around 170-180 degrees which would be probably about 20 min of driving roughly from a cold start for fuel trim tuning for idle and part throttle because the trims will be different when the oil temp is colder and it'll have you chasing your tail trying to dial them in - other than that your logging the important stuff
make sure your not getting knock and after a flash drive for about 5-10 min to get rid of the heat soak and reset the fuel trims
don't hesitate to come back if you need further help - also the pe ratio is good where its at for a direct injection setup - happy tuning