Trans Throttle Torque Source, Throttle Closing, +STFT

[06300CSRT8]

Can you guys help me figure out where in my tune I am triggering some sort of limit, just not seeing it...

If you look at my log 1, right during my 1st gear launch, at 1mph and 2700rpms I am getting a quick "Trans" torque source blip, it was very slight and in that log didn't close the throttle on me, in log 2 you can see it clearly close the throttle on me. I was feeling the car almost like just sit there for a moment, so it def was effecting my 60' times.

The second issue is in log 1, right after my 1-2 shift, throttle was closed, STFT's went positive, which has to be some torque management kicking in as the car is running in open loop. Thoughts?

LOG 1.hpl
LOG 2.hpl
Diablo Tune 1_3 Bar_v.hpt

[ElecTech]

Try the [TCM] 41850 table and any of the "Use ETC" switches in the ECM Torque Management tab.

[06300CSRT8]

Thanks - I cannot locate that TCM table, what is the name of it?

Curious your thoughts on the STFTs as well, sent my AFRs between shift to below 10.0