Can not read stand alone data log from MPVI Pro

[magredvet]

So first off I am on 4.x, No beta user here.

I drove the car to work doing the stand alone data log. Started normally and recorded the drive in. Plugged in to PC and pulled the log. Showed 24 minute plus drive, no issue there. The problem comes when I try to view it. Its like half the data isn't viewable. I opened a good known config file in the scanner, wrote it to the box and datalogged my drive home. Same thing...

I loaded a log from 11/17 that was recorded with the same method, totally viewable.

Car is a 2004 Corvette

Chris

8-6-18 DRIVE TO WORK.hpl
07-19-17 DRIVE TO WORK BRAF ADDED #2.hpl

[tek1229]

I've been having issues with the beta 3.6 doing the same thing..

For now I've been using the 3.6 regular version scanner and it's working normally to read the logs from the MPVI.. Once I've read and saved them I can open them in the 3.6beta and the 4.0 software..

[magredvet]

I may just load 3.6 back on my PC at work and see if changes or for even that matter need to see if it data logs with the laptop I don't mind lugging it around.

Chris

[Bill@HPTuners]

looks like its only the SAE pids you are logging that aren't showing up, I would recommend repolling to rule that out as an issue and try readding the pids to the channels and run another test. If you continue getting the same results email support.

[magredvet]

Bill,

Thanks for looking at it. I will recheck my settings.

Chris