Coyote Bench Harness pinout

[Brice]

I'm looking for the Coyote ECM pinout for a bench harness, I haven't found anything.

[Cozmo2806]

I have it, can post later tonight.

[Brice]

have you found it ?

[txcharlie]

Try this.

[Sleek98]

Here are the pinout for a 13/14 body, trans and engine into the ecu.

[MH7]

Hello, does anybody have the same complete pinout for 2019 GEN3 Coyote?

[shopore]

Hello, does anybody have the same complete pinout for 2019 GEN3 Coyote?

Hi, did you end up finding this? Im after it too.

[veeefour]

Hello, does anybody have the same complete pinout for 2019 GEN3 Coyote?

sure, here you go, gen 3 pcm has 3 connectors: engine trans and vehicle. Here's the 3rd one that you need "E".

this is a minimum if you need to bench it:

image.png

[amps1956]

how about what wires are needed for a gen 1 I am just wanting to run one on a stand with a computer and what i need to start even in limp mode i am just wanting to check motor out