2005 GTO, E40, Flex sensor
My alcohol percentage used to work in my Channels. Now I cannot get it to read on either of the Alcohol selections. The Sensor that reads in Frequency works but I don't know what 118hz is equal to in percent. Is there some way to change frequency to percent? I have Alcohol percent shown in charts also and no numbers there.
I found a chart that lists hz as a percent of alcohol, so I guess I will use that.
Last edited by Lakegoat; 04-17-2018 at 02:36 PM.
2000 Camaro SS 2015 L83 port injected, Whipple 3.0, 4L80E, 8.8 Ford
2013 Silverado 5.3, 6L80k 8.8
Did you try repolling for supported parameters and going back in to see if you could add the channels after that?
No, I haven't. How do you repoll?
Thanks
2000 Camaro SS 2015 L83 port injected, Whipple 3.0, 4L80E, 8.8 Ford
2013 Silverado 5.3, 6L80k 8.8
scanner top left under "vehicle" should be in the middle bunch of options
With the interface connected to the vehicle in the scanner go to the vehicle tab select repoll for supported parameters.. after it's done click on the add Channel gear.look under fuel system>composition
Thanks! That did it. I don't know why sometime things change in the scanner. I made two drag runs last night and my tps read 37% when it was 100 and trans temp read 32 degrees.
2000 Camaro SS 2015 L83 port injected, Whipple 3.0, 4L80E, 8.8 Ford
2013 Silverado 5.3, 6L80k 8.8
I lose channels all the time for some reason. And it really sucks if you go out and waste a bunch of time and gas logging and then don't have the chanels you needed working when you go to look at the data. I've made it a point to verify I'm logging everything I need every time I hook upOriginally Posted by Lakegoat
2010 silverado 6.2 ,Doug Thorley try-y headers, cats deleted ,spectra air cold air, lifted with 33's,tsp vvt 1.2 cam hp tuners
Reply With Quote