-
Tuner
trouble reading a 2011 tahoe powertrain swap. any ideas?
I'm working on an old street rod that someone has swapped a 2011 Tahoe drivetrain into. The scanner hooks up fine, when I try to read the tune in vcm suite, it will start to read for about 10-15 seconds. I can watch the "time remaining" go from 2 minutes to 111 minutes and then it fails and says "timed out". what could be causing this?
-
Tuner
First thing that comes to mind, is why is the car there? Random electrical problems?
I would also try reading another vehicle to be sure HPTuners is working properly.
Typically things timing out means that a device sent a request and the request wasn't answered. This could mean dead ECM/TCM, bad wiring (short to ground on can bus), improper request sent, locked ECM/TCM, bad message sent, or even just low system voltage.
Are values actually being reported in VCM suite?