Results 1 to 3 of 3

Thread: My basic tune so far errors?

  1. #1
    Potential Tuner
    Join Date
    Jul 2006
    Location
    Blaine, Minnesota
    Posts
    2

    My basic tune so far errors?

    I just recently picked up HP Tuners and have been reading everything I can and looking at as many tunes that are similar to my vehicle as I can. Attached file is a copy of my basic tune so far. I was wondering if you vets can give it a look over and let me know if there are any glaring mistakes and throw out a tip or two.

    What I attempted and hopefully did: turned off rear o2 sensor errors, turned COT off, firmed up trans shift pressure, removed all TM, adjusted my fans running stock thermo, and raised the speed limiter.


    2005 GTO A4
    Kooks LT w/off road pipes, Volant CAI, NGK TR55's .60 gap, arriving soon magnaflow cat back exhaust.


    Thanks

  2. #2
    Tuning Addict WS6FirebirdTA00's Avatar
    Join Date
    Jan 2005
    Location
    Concord, NC
    Posts
    8,093
    First of all, I would tighten up the gap on your plugs, hopefully you really meant 0.060" lol, but I woudl run them about 0.050-0.055 for a bolt on car. Just has worked better for me.

    So far it looks ok, I am not sure on the tranny settings as I do not know how the stock values are. There are a few guys around here that are really sharp on the tranny settings, maybe they can comment on that.
    Sulski Performance Tuning
    2000 WS6 M6 - LS6 (long block, refreshed top end), 10.8:1 CR, 90 mm ported FAST, Exo-Skel, 227/232 cam, QTP HVMC, EWP, GMMG, 9" w/4.11s
    2018 Sierra SLT 5.3L A8 - Airaid intake tube, GM Borla catback, L86 Intake/Ported TB

  3. #3
    Potential Tuner
    Join Date
    Jul 2006
    Location
    Blaine, Minnesota
    Posts
    2
    Stock file is below