hi
As the title says there is no "X"in right upper corner to close the graph, charts or gauges windows.
What should I do? I have tried to move the windows over but there is no x.
hi
As the title says there is no "X"in right upper corner to close the graph, charts or gauges windows.
What should I do? I have tried to move the windows over but there is no x.
Jump to fullscreen, its probably off the edge...
99 TA, Texas Speed LS376, PRC heads, 233/239 cam, Fast 92mm, 95mm TB, card style MAF, Tick TR6060, Strange 4.11 12 bolt axle & clutchpack diff, Strano springs/dampers, Vette 18" wheels, Vette disks, CTS-V calipers, 16lb flywheel, long tube headers, no cats.
Thank for the reply. I did full screen and reduced screen. Tried moving the windows to try and find the X. No go.
Layout Menu, uncheck Lock Layout
We got this guy Not Sure, ...
Should be the last thing in the list.
Up at the top.. log file, vehicle, layout, tools, help... pick layout, then lock layout
There's a little mark to the left. Just select it and see if anything changes as far as your issue goes.
Post a log and tune if you want help
VCM Suite V3+ GETTING STARTED THREADS / HOW TO's
Tuner by night
CPX Tuning
2005 Corvette, M6
ECS 1500 Supercharger
AlkyControl Meth, Monster LT1-S Twin, NT05R's
ID1000's, 220/240, .598/.598, 118 from Cam Motion
2007 Escalade, A6
Stock
Down loaded 3.6 same issue. Unchecked lock layout as Kieth said to do and the X appeared. Thanks Keith!
I check that before because if I didn't the Layouts I created would revert back to the default layout even though I saved it. So I hope that doesn't happen again.
Christian