Originally Posted by
imgarten.fredrick
I have tried modifing them by hand as well and when I calculate coefficeints it modifies a ton of cells around it. And then when I get to logging again, I will be lean, the entier fuel trim table will be very lean.. If you check back in a couple hours, I will upload the log it gives me after I get close to zeroing out the table then multiply percent half and save it.
Can it just be running lean after a flash instead of rich? I just cant explain well myself. I can tune a file a few times on the VVE and then all of a sudden when I get it close to being really good, I'll edit the table and save and upload. Start the car, log right away or wait for it to clear out, it doesn't matter. it is lean all of a sudden. The entire table. This is what is confusing me.