Morning guys
I have a issue with a 2007 holden commodore, We have worked on the vehicle previously.
The car was originally a v6 version sv6, and had a L98 conversion with OTR, full exhaust, Large cam etc.
We tuned the car and the everything went perfect.
The owner has since had a auto to manual conversion, which was carried out buy another shop, it was towed to us to get retuned.
I have flashed in a complete v8 manual OS into the vehicle and carried out changes to tune to get it running good.
The issue im having is the scanner drops out after 5-10 seconds of running, so i cant data log.
I also get a "ABS" light and numerous CAN-BUS com codes, If i attempt to connect to any module with a scan tool it wont
connect unless i cycle the ignition, its like the connection times out?????
Its like something is crashing the CAN-BUS
I have an "invalid vin match" code inside the ABS module. I cannot use the Vin wizard to change the vin to match the Pcm vin
with the vehicles other modules as the pcm recognises it as an incorrect (previously V6 OS now V8)
But i assume this should not be an issue as the PCM has always had a different vin as the body modules.
When they have done the conversion they have replaced the ABS module as part of the conversion kit and apparently programmed.
Just wondered if anyone has done a conversion or has any ideas what the issue could be.
I wana check all my side of things before i send it back to the dealer.
Thanks in advance