Setup gauge with limited display range

[Widebody06]

So with 2.x I could use the wb setup graph to determine the values to have an HPT gauge display 10-18 AFR instead of the whole 7.35-22.xx range which corresponds to 0-5v. With 3.x I get the limit range indicator instead of an actual scale change. Using an LC-2 and volts/.3324 +7.35 for translation as the basic channel setup, haven't tried it for function yet in 3.x but regardless would like the display to be what I want. Any info on scale/range limiting?

[Mr. Smith]

If you're talking about what I think you're talking about, then it's piss-easy. I just made a AFR gauge last night.
- Right click in VCM Scanner
- Select Gauges Layout
- Select the gauge you wanna mod
- Check the bottom/right area where it says "Ranges".
- Enter the "ranges" you want
wait... let's see if this screenshot works..

AFR settings.jpg



Mad.. it did.

[schpenxel]

Yeah, I'm not sure what you're asking

You can change whatever you want on the gauge in terms of lowest value and highest value, where those low/high values are on the gauge, and also where you want yellow/red warning bars

[Widebody06]

So while maybe there are no dumb questions, this one is a near miss. Even though the sensor will be reporting values from 7.35 to 22.x its only going to display what ever values are between my limits. Guess I over thought that one...

[Mr. Smith]

So while maybe there are no dumb questions, this one is a near miss. Even though the sensor will be reporting values from 7.35 to 22.x its only going to display what ever values are between my limits. Guess I over thought that one...

Yeah and like I + Schpenx wrote/indicated/showed.. you can easily change your max/min. values/ranges if you wanted to.

You're welcome.