I just installed a flex fuel sensor.
Pink wire to 12v ignition
Black to ground
White to pin 5 of J1 (blue) ECM plug.
I get remote tunes as I am a long way from tuning on my own.My tuner is unavailable. I am not getting a reading from my sensor when I datalog. I am very confident I wired the pin properly. If anyone has a moment can they look at my tune to make sure everything is correct for it to work?
Last edited by Trackman101; 10-05-2016 at 03:47 PM.
Enabling the sensor would be an obvious place to start...
fuel-->open/closed loop, Flex fuel sensor "enable", sensor type "sensor"
Post a log and tune if you want help
VCM Suite V3+ GETTING STARTED THREADS / HOW TO's
Tuner by night
CPX Tuning
2005 Corvette, M6
ECS 1500 Supercharger
AlkyControl Meth, Monster LT1-S Twin, NT05R's
ID1000's, 220/240, .598/.598, 118 from Cam Motion
2007 Escalade, A6
Stock
Thank you.^^
I saw that in the tune and just didn't have the confidence to change it without a knowledgeable 2nd opinion. I was told the new tune was flex fuel ready.
Yeah looks like they missed those. I didn't check but make sure the stoich AFR table is setup correctly also
Reply With Quote