PE Enable Torque table for a DI motor

[benf]

I have seen people set this table in a wide variety of settings, anywhere from 100 down to 35. Curious to what some are running for this table for a DI motor. Currently i am running 40's and 35's in the table.

[jtrosky]

I have my 2012 Impala (3.6L LFX motor) set to 40 across the board. I mainly set it that low so that my pedal position dictates when PE is enabled. I have my Pedal Enable set to 61.3% from 0-5632rpm and it does down from there (down to 35.8% at 8192rpm (which I'll never actually reach obviously)...

It seems that a lot of folks set the Enable Torque very low and use the Pedal Enable to dictate when to go into PE...

For comparison, my stock Torque Enable was 95% across the board and the stock Pedal Enable was 90% up until 4068rpm and then down to 45% at 8192rpm (goes down gradually between 4068 and 8192rpm).

As to *why* I set it like this... No particular reason - just wanted to bring PE on a little earlier...