Black Oak 0ECU 03 XR8 failed erase

[hrt042]

Guys I have a black Oak ecu in a 03 XR 8 that I did a read on, modded the file saved now on write it erases to 95% stops and times out, have disconnected the battery, started again from scratch, used a jump pack on the battery etc, regardless it erases to 95% then stops.

I have had writing issues on a Black Oak in a GT before but persistence paid off. and I wrote it 5 or 6 times. This one stops always at 95% on the erase, never gets to actually writing. Currently stuck on the dyno.

Using 3.0.110 or 3.1.62 Beta

Any ideas? Tried everything I can think of.

[JETURBO]

Take an info log and the vin number and send it to support , had it happen before and don't expect a fast turnaround so make tentative plans for the customer

[hrt042]

Thanks will do.

[Peppy_t]

Yep what jet said, I had it happen to a BA 6t.. Email support, they asked for the stock file, modded file, info log and debug.dat file, it was sorted within a week from memory

[hiddeous]

where are you located?