Ever since upgrading to the 3.0 version, my scanner and editor graphs no longer match, so doing a copy/paste special is not useable. What happens is it will change the wrong parameters, in the wrong areas...
The scanner now skips over many of the RPM areas...
Basically, the scanner only registers every 400 RPMS, but the Editor registers every 200 RPMS...???
I attached pics of both, and am hoping it's just a simple tweak of the scanner configuration, of which I have very little experience in...
How do I get these two graphs to register the same?
HPT1 (640x360).jpgHPT2 (640x358).jpg