LC1 with hptuners Pro A/F readings extremely rich?

[Eloc]

I just installed an LC1 with hptuners did the whole add EOIO and make sure LC1 is selected. Did the free air calibration and such installed the sensor(Which is used). Now I'm reading 7.36 as my A/F in hptuners. Just wondering if a decently running car could possibly be running this rich or is the sensor or my hptuner settings off? I have a scan of me revving it a few times but not moving and it holds around 7.3. AFissues.hpl

[mowton]

No would say your WB is not setup properly...post a screen shot. By your use of "EOIO", I would say you are using 2.24.

Also I never see your commanded AFR do anything but 14.68, even with a MAP of 100 kPa...be careful. Figure out why you aren't going into PE..

Ed M

[Eloc]

I meant EIO if that matters. I believe I have the newest version as I bought it this august? And hmm very true thanks I'll look into that

[Eloc]

I didn't go into PE because my tps setting on it is 90% so no issue there. Still confused on why the wideband isn't reading correctly :/ but ah well I shall try doing another free air calibration

[mowton]

I didn't go into PE because my tps setting on it is 90% so no issue there.

WOT at 100+ kPa, 4000 rpm and 17+ms of injectors, I would be worried.....

Ed M

[jimmyblue]

Have you verified what the transfer-function is, as
the LC-1 puts it out? I know my LM-1 will put out an
arbitrary scale & offset that can be programmed, and
uses a default I don't much care for. What's the source
instrument have to say, and what does the HPTuners
wideband function (also programmable, with some
default or remembered-setting) "receiving" the voltage
think it means?