Noob Question: MAF Tuning Histogram

[Shockerman80]

I apologize for posting this but i haven't been able to find the info through searching. I haven't been able to find what sensors and how to setup the histogram for scanning the MAF sensor. i think i have it figured out but i would like someone to check to make sure im right before i start using wrong data. Thanks for your time.
Using 3.0 hp tuners pro.

History of the car

1986 monte carlo ss
07 tbss ls2 swap t56
Gmpp Ecu kit LS7 Style maf E67 Ecu
innovate lc1 wideband.
Killed the VE table, Dfco, ltft,

idle maf test.hplgood tune ve disabled maf enabled1.hptlayout hptuners.Layout.xml

[schpenxel]

Post the layout you are using so we can see what you've got histogram wise

Are you using 2.24 or the new V3? 2.24 is no longer supported so you will get a lot more support if you're using V3, IMO

Just looking over the tune real quick your dynamic airflow settings are not quite right for MAF tuning--where you have 2000 RPM's change it to 200

[Shockerman80]

Ok thanks i saw that when i looked at it quick just after i uploaded it. I thought the layout would follow the log but i was wrong. Thanks for the help. Ill have to up load the layout. My mistake.

[Shockerman80]

fixed the info

[schpenxel]

I made a couple of changes to your layout, see attached.

If you're in closed loop then you can use fuel trim values for MAF corrections (while not in PE mode). I've setup 2 histograms for that, then you still have the ones you originally made for tuning WOT with wideband/AFR error

Obviously you'll need a longer log.. but hopefully this gets you started

layout hptuners.Layout.xml

[Shockerman80]

Thanks for the help it's appreciated. Hopefully this thread will help others as well