3.0 Wideband Reading Off, How to Adjust?

[XDR]

My LC-2 reads 0.2 higher in HP Tuners 3.0 scanner vs the Innovate Log Works. For example, when reading 14.6 in Low Works (via serial), HP Tuners would show 14.70-14.90. I know that you can adjust this with a custom pid in the old version, but how is this done on 3.0?

[mowton]

Transform the wb like you did previously from the channel table, single click the LC-2 wb name and look above for the Fx which should now be illuminated. Click that and the User defined editor will take the place of the predefined. subtract .2 from the last number (V/X.XX+ Y.YY) and hit ok. Relog and check, tweak as needed. It's basically the same approach as 2.24. Reload the Chart and Graph Parameters as necessary.

Ed M