3.0 and Readiness Monitor Status

[imphat0260]

Anyone else having issues with Readiness Monitor Status not displaying in 3.0? I don't seem to be having problems with any LSx stuff, just have been getting hit/miss results with LNF. Also have latest version of 3.0 .

[Keith@HPTuners]

What do you mean it doesn't display?

[imphat0260]

What do you mean it doesn't display?

I mean I click read DTCs, DTCs will show if present, but the chart showing the readiness monitors is completely blank.

[Keith@HPTuners]

Can you post a screenshot?

[imphat0260]

Capture.JPG

[Keith@HPTuners]

What version of windows?

You may need to contact support.

[imphat0260]

What version of windows?

You may need to contact support.

7. Same thing happens on multiple laptops (1 less than 3 days old)

[Keith@HPTuners]

You'll have to contact support.

[ECaulk]

7. Same thing happens on multiple laptops (1 less than 3 days old)

Let me know what support says, I get the same issue with my LNF (not overly concerned other than is doesnt work suddenly).

[imphat0260]

Let me know what support says, I get the same issue with my LNF (not overly concerned other than is doesnt work suddenly).

I haven't sent to support yet (been too damn busy), but I found that if I read DTCs without scanning/logging, the readiness monitors show up, but if I'm logging they won't.

[ECaulk]

I haven't sent to support yet (been too damn busy), but I found that if I read DTCs without scanning/logging, the readiness monitors show up, but if I'm logging they won't.

I'll have to use that method, thanks for updating with a work around.

[Mike's LS3]

Same here. Once I stop scanning, then click DTC the readiness monitor status appears.

[dllhg]

Funny because 2.24 was exactly the opposite. Had to click scan to show readiness.....

[Ian steiner]

Are you having an issue that during scanning it will only scan for maybe a minute and then stop scanning?