So I have a 5 wire MAF and am wondering if setting my MAF Frequency fail high DTC set very low is a good way to set the fail DTC and still get desired results. I'm very green at everything and trying to not break stuff.
So I have a 5 wire MAF and am wondering if setting my MAF Frequency fail high DTC set very low is a good way to set the fail DTC and still get desired results. I'm very green at everything and trying to not break stuff.
Set the Maf Fail High Frequency to 0 set the DTC for MAF fail High should be set to fail first error.
I tried all that and went in to limp mode... twice. How can I fail without going into reduced power?