Curious when we will get FULL support for the 8speed auto???
Would love to make changes like I did on the 6speed, currently tq management is just on/off, etc
Curious when we will get FULL support for the 8speed auto???
Would love to make changes like I did on the 6speed, currently tq management is just on/off, etc
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
I second this, at least need desired shift times and inertia tables added along with actual specified units in the torque limit tables.
2016 C7 Z06 | 2017 ZL1 | 2009 C6 Z06 | 1994 GT - The LS-stang | 2010 Tahoe SSV
Definitely need more settings...the adapt resets every flash and then shifts hang. I only added 5% to base pressure.
Yea every damn trans write first shift is terrible....
Vendor on the corvette forum is talking about 8speed tuning with auto cal.... Don't see how he can be doing much other than disabling stuff lol
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
Sorry about that guys. We will have an update done to our 8 speed definitions within the next month.
Sounds good
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
Ah, thank you for posting this. I got my new Sierra with the 6.2l and 8spd auto and how if shifts is killing me compared to how I had my 2014 truck setup.
and here I was wondering where the pattern B part throttle table was...
Today's software has a comprehensive update for A8 transmissions thanks to one of our diligent engineers.
Very nice!!!
I'll check it out later
Thanks
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
Good update... I know you guys are working hard, still like to see more
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
On the transmission side, under the shift times tables. It only shows the tables like this is a 6L80E. I was in the upshift tables and downshift tables, at least that is where I saw it. I made sure to log into my portal and download the newest update and install it. I think it went from 3.24.077 revision to 3.24.080 revision.
2016 GMC Sierra, 6.2l with the 8L80E
Just verified again, just updated to 3.0.78 just a bit ago and still same issue. Under transmission>part throttle shift speed - I am seeing nothing but upshift, downshift, upshift 5th, downshift 5th, upshift 6th, downshift 6th, D1 and D2.
Nevermind, I am a idiot. I had the wrong file open.