My LC2 Does the same thing it reads normal until you start the vehicle then it reads in the 500'sOriginally Posted by country_3030
My LC2 Does the same thing it reads normal until you start the vehicle then it reads in the 500's
Some say the LC1 works for them and not for others. Could it be the serial adapters being different?
I tried 3 different adapters one of which was directly from innovate just to be sure, an all have had the exact same results.
I have 3 ALM Ecotron 4.9 widebands and I use serial comms in efilive with them all the time, so can provide feedback if you add support in your software that would be appreciated. Prior to serial support it's 1 of the main reasons i didn't use hpt as my primary software choice.
The comms spec document is here:
http://www.ecotrons.com/files/ALM%20...%20-%20SCI.pdf
Last edited by Tre-Cool; 03-22-2016 at 12:12 PM.
Has LC-2 been fixed? What advantages are there for running serial input vs running it through the HP Tuners MPVI? I've heard that serial is slower, is it slow enough to effect readings in a negative way?
Any news with plx? I have it running via scanxl no problem, on hpt scanner disappears.
If you need some tests, I can do for you.
Eastern and Central Europe American Muscle and Harley-Davidson tuning
www.hd-customs.pl
http://www.facebook.com/hdcustomspl
I have the NGK/NTK wide band has it been implemented in yet?
