Dialing in Torque Inverse

[Eric@HPTuners]

I've just added a scanner parameter that will show you the torque value that the PCM is using to determine the location you are in the Torque Inverse table (Y axis).

This parameter is ID 12529. It is called Engine Indicated TQ Reference

This should help simplify this tedious task.

So far it is only in the TC-1791 definitions, but will be in the Copperhead and other PCM definitions very soon.

[Higgs Boson]

What is the TC-1791? 15/16?

[MattH@HPTuners]

15-Current Mustang V8/V6

[caniggia]

Wow, that's long time needed

[Blueprint]

Was this added for 11-14 copperhead?

[Eric@HPTuners]

Its in many of the more popular copperhead OSID scanner definitions, and being added to everything as time permits.

[Blueprint]

Is the parameter labeled the same for 11-14 cars? Not seeing it in my OSID, guess I will keep an eye out!

[15PSI]

Thanks Eric. I just found it in my strategy (FPDW3FA). I am going to test it in an hour. This should be very helpful.